4CR 6.9752.0001, Operation Manual

Page: 6 / 10

4. Operation
1. Connect the electricity. The supply cable must be at least 4mm ² at 230V.
Make sure the supply voltage and frequency are as specified correspond to the type
plate of the device.
2. Set the distance between the device and the workpiece. Usually a distance of 30 – 60
cm is to be kept.
3. Switch on the device with the ON / OFF switch. Set time and temperature according
to the manufacturer’s specifications of the applied materials to achieve the desired
result.
4. After the timer has elapsed, switch OFF the device with the ON / OFF switch.
5. After use, disconnect the device from the power supply and store it in a safe place to
Prevent improper handling and damage to the device and the fluorescent tube.
Watch out! Device heats up during use. Injury and fire hazard!
Switch off the appliance after use. Store the device in a safe place to avoid
damage.
ON/OFF TIMER
4