3xLogic VISIX S-Series, Installation Manual, Page: 32 / 110

Installation Manual v3.1 | VISIX S-Series Network Camera
12000 Pecos Street, Suite 290, Westminster, CO 80234 | www.3xlogic.com | (877) 3XLOGIC 31
(OPTIONAL) INSTALLATION OF NETWORK CABLE WATER-PROOF JACKET
Purpose:
If the camera is installed outdoors, you can install a waterproofing jacket for the network cable after the
camera is secured to the installation surface.
① ②
③
④
⑤
⑥ ⑦
Water-proof Accessory Components
Table 1-1 Components
No. Components
1
Camera ’ s Network Interface
Socket
2 O-Type Gasket
3 Network Plug
4 Waterproof Endcap
5 Waterproof Rubber Gasket
6 Lock Nut
7
Network Cable from
Router/Switch
Steps:
1. Feed the plugless network cable ⑦ through the lock nut ⑥ , waterproof rubber gasket ⑤ (the
rubber gasket inset ridge must face the waterproof endcap), and the waterproof endcap ④ in order.
2. Crimp an RJ-45 network plug ③ onto the end of the cable, taking care to insert the twisted pairs of
wires in correct order.
3. Place the O-type gasket ② onto the end of the camera ’ s network interface socket ① .
4. Insert the network plug ③ into the c amera’s network interface socket ① .
5. Insert the waterproof rubber gasket ⑤ into the waterproof endcap ④ , and secure lock nut ⑥ with
the waterproof endcap ④ .
6. Align the snap on the waterproof endcap ④ with the notch on the camera ’ s network interface socket
① , and then secure the waterproof endcap ④ to the camera ’ s network interface socket ① to finish
installation.