19
Special instructions
for Waterproof Case
The camera is only
submersible up to 2M if it is
correctly sealed within the
supplied Waterproof Case.
Before sealing the Waterproof Case, keep the camera
housing’s rubber seal clean. A single hair or grain of sand can
cause leaking. You must test it by closing the case without
inserting the camera. Submerse the case completely in water
for about one minute. Remove the case from the water, dry off
its exterior with a towel, and then open the case. If the interior
is dry, the case is safe for use under water.
• After use in salt water you will need to rinse the case
appearance parts with fresh water and dry it. This will
prevent corrosion of the hinge pin, which can cause failure.
• To clean the seal, rinse in fresh water and wind dry (drying
with a cloth may cause lint to compromise the seal).
Re-install the seal into the grooves in the backdoor of the
housing.
Failure to test the Waterproof Case before use
may lead to subsequent damage of your camera
and void warranty.
