RUN
ON
Device is not started or abnormal
Blinking
Blinking 1 time per second, system
is running normally
OFF
The device is powered off or the
device is abnormal.
ALM
ON
Power supply or port link has alarm
OFF
Power supply and port link have no
alarm
P1-P2
ON
Power supply is running normally
OFF
Power supply is disconnected or
running abnormally
X1-X4
、
G1-G24
ON
Ethernet port has established a
valid network connection
Blinking
Ethernet port is in an active
network status
OFF
Ethernet port has not established
valid network connection
【
Logging in to WEB Interface
】
This device supports WEB management and configuration.
Computer can access the device via Ethernet interface. The
way of logging in to device’s configuration interface via IE
browser is shown as below:
Step 1
Configure the IP addresses of computer and the
device to the same network segment, and the
network between them can be mutually accessed.
Step 2
Enter device’s IP address in the address bar of the
computer browser.
Step 3
Enter device’s username and password in the login
window as shown below.
Step 4
Click the “login” button. Change the initial password
when logging into the device for the first time, after
that, relog into the device to access the device's
Web interface.
Note:
The default IP address of the device is “192.168.1.254”.
The default username and password of the device is
“admin123”.
If the username or password is lost, user can restore it to
factory settings via device DIP switch or management
software; all modified configurations will be cleared
after restoring to factory settings, so please backup
configuration file in advance.
Please refer to user manual for specific configuration
method of logging in to WEB interface and other
configurations about network management function.
【
Specification
】
Panel
10Gigabit SFP+
1000/10GBase-X self-adaptive
SFP+ slot
Gigabit SFP
100/1000Base-X self-adaptive
SFP+ slot
Gigabit copper port
10/100/1000Base-T(X)
self-adaptive RJ45, automatic
flow control, support full/half
duplex mode, MDI/MDI-X
self-adaption
Console port
CLI command management port
(RS-232), RJ45
Alarm interface
6-pin 5.08mm pitch terminal
blocks, alarm occupies 2 pins,
support 1 relay alarm output
Indicator
Running Indicator, Alarm
Indicator, Power Supply
Indicator, Interface Indicator
Switch Property
Backplane bandwidth
128G
Packet buffer size
12Mbit
MAC address table
16K
Power Supply
Input power supply
12~48VDC redundant power
supply, support anti-reverse
connection
Access terminal block
6-pin 5.08mm pitch terminal
blocks (power supply occupies 4
pins)
Power Consumption
No-load
15.4W@24VDC
Full-load
30W@24VDC
Working Environment
Working temperature
-40
～
65
℃
Storage temperature
-40~85
℃
Working humidity
5%
～
95%(no condensation)
Protection grade
IP30(metal shell)