table below:
LED
Status
Description
PWR
ON
The power connection is operating
normally.
OFF
The power is not connected or is
not working properly.
LINK
ON
The copper port has established
an active network connection.
Blinking
The copper port is in a network
activity state.
OFF
The copper port does not establish
an active network connection.
TX(1-2)
OFF
The serial port is not sending data
or sending abnormally
Blinking
The serial port is sending data
RX(1-2)
OFF
The serial port is not receiving data
or receiving data abnormally
Blinking
The serial port is receiving data
【
Logging in to WEB Interface
】
This device supports WEB management and configuration.
Computer can access the device via Ethernet interface. The
way of logging in to device
’s configuration interface via IE
browser is shown as below:
Configure the IP addresses of computer and the
Step 1
device to the same network segment, and the
network between them can be mutually accessed.
Enter device
’s IP address in the address bar of the
Step 2
computer browser.
Enter device
’s username and password in the login
Step 3
window as shown below.
Click
“OK” button to login to the WEB interface of
Step 4
the device.
Note:
The default IP address of the device is “192.168.1.254”.
The default username and password of the device is
“admin”.
If the username or password is lost, user can restore it to
factory settings via device DIP switch or management
software; all modified configurations will be cleared
after restoring to factory settings, so please backup
configuration file in advance.
Please refer to user manual for specific configuration
method of logging in to WEB interface and other
configurations about network management function.
【
Specification
】
Panel
100M copper port
10/100Base-T(X)
self-adaptive
RJ45 port
Serial port
RS-232 RJ45 port or RS-485/422
terminal
Indicator
Power indicator, network Link/Act
indicator, serial port transmission
and receiving data indicator
Power supply
Input power supply
9
～
48VDC
Access terminal
2-pin 5.08mm terminal
Consumption
Model I
No-load: 0.79W@9VDC
Full-load: 0.86W@9VDC
Model II
No-load: 0.90W@9VDC
Full-load: 1.25W@9VDC
Working
environment
Working temperature
-40
～
75
℃
Storage temperature
-40
～
85
℃
Working humidity
5%
～
95% (non-condensing)
Protection grade
IP40 (metal shell)
