Check whether the DIN-Rail mounting kit that
Step 1
comes with the device is installed firmly.
Insert the bottom of DIN-Rail mounting kit (one side
Step 2
with spring support) into DIN-Rail, and then insert
the top into DIN-Rail.
Tips:
Insert a little to the bottom, lift upward and then insert
to the top.
Check and confirm the product is firmly installed on
Step 3
DIN-Rail, and then mounting ends.
【
Disassembling DIN-Rail
】
Power off the device.
Step 1
After lift the device upward slightly, first shift out the
Step 2
top of DIN-Rail mounting kit, and then shift out the
bottom of DIN-Rail, disassembling ends.
Attention before powering on:
Power ON operation: first connect power line to the
connection terminal of device power supply, and then
power on.
Power OFF operation: first unpin the power plug, and
then remove the power line, please note the operation
order above.
【
Power Supply Connection
】
DC power supply
The device provides 3 pins 7.62mm
pitch terminal blocks. The power
supply supports nonpolarity and
anti-reverse connection. It can
normally operate after reverse connection. Power supply
range: 12
～
48VDC
【
Checking LED Indicator
】
The function of each LED is described in the table as below:
LED
Status Description
PWR
ON
PWR is connected and running
normally
OFF
PWR is disconnected and running
abnormally.
Link/Act
(G1-G8)
ON
Ethernet port connection is active.
Blinking Data transmitted
OFF
Ethernet port connection is inactive.
【
Specification
】
Panel
Gigabit copper port
10/100/1000Base-T(X)
self-adapting RJ45 port, full/half
duplex self-adaption, support
MDI/MDI-X self-adaption
Indicator
Power indicator, interface
indicator
Exchange attributes
Backplane bandwidth
20G
Packet buffer size
2.5Mbit
MAC table size
8K
Power supply
Input power supply
12~48VDC
Support nonpolarity and
anti-reverse connection
Support built-in overcurrent 4.0A
protection
Access terminal
3 pins 7.62mm pitch terminal
blocks
Consumption
No-load
0.82W@24VDC
Full-load
3.65W@24VDC
Environmental Limits
Working temperature
-25
℃
~70
℃
Storage temperature
-40
℃
~85
℃
Working humidity
5%~95% (no condensation)
Protection grade
IP40 (metal shell)
