21
4.3 Serial port setting
4.3.1 Baud rate
Data format:
Length Message
Source
Message
target
Reserve Opcode Command beeper Check
Sum
0x0B
0x04
0x31
0x00
0x50
The baud rate is the rate at which bits are transmitted from the reader to the host, and
vice verse. Both the reader and the host should be set to the same baud rate.
The data characters may be transferred in one of the following formats:
A parity bit may be added to every character so that the total number of 1’s in the data
bits, together with the parity bit, is odd for odd parity or even for even parity.
Command:
%
SET
2400 baud
C0000
4800 baud
C0001
*9600 baud
C0002
19200 baud
C0003
38400 baud
C0004
57600 baud
C0005
115200 baud
C0006
Note: The baud rate of the scanner should be the same as the baud rate of the host
device, so the data can be transmitted normally.
Summary of Contents for SC050
