24
Enable and Disable Ambient Light and Proximity Sensor in BIOS
Step 1: Start up the system
Step 2: Press [ Delete ] during startup to enter BIOS
Step 3: Under Advanced > Sensor Device Configuration click Disabled to turn off, Sensor 1 to
turn on proximity and ambient light sensor.
Note: The factory default setting for the sensor is Enabled.
Hardware
Accessing the Memory
Note: This is a general reference assembly guide, the actual display size product. It will not matter to the assembly. Make
sure the system is off.
Tools Needed: You will need to prepare a screwdriver in order to access the Memory.
STEP 1: Place the panel pc fading down on a flat surface. With a precision screw driver remove the one screw.
Place the panel pc facing up on a flat surface. With a screwdriver, release the two screws.
Summary of Contents for PP-9745
