3M X56, Safety Manual

Page: 17 / 26

17 © 3M 2011. All rights reserved.
Product Warranty and Safety Guide
EN
GLISH
3M™ Digital Projector X56
This projector has internal clock that uses a battery. When the clock of
the network function does not work correctly, please replace the battery.
HITACHI MAXELL, part number CR2032 or CR2032H .
1. Turn the projector off, and unplug the power cord.
Allow the projector to cool suffi ciently.
2. After making sure that the projector has cooled
adequately, slowly turn over the projector, so that the
bottom is facing up.
3. There is a raised dot near the battery cover at the bottom
of the projector. Turn the cover in the direction indicated
“OPEN” to position the slit on the cover with the dot,
using a coin or the like. Lift the cover up to remove it.
4. Pry up the battery using a fl athead screwdriver or the
like to take it out. While prying it up, put a fi nger lightly
on the battery since it may pop out of the holder.
5. Replace with a new battery of the specifi ed type. With
the plus side facing up, slide the battery under the claw
of the spring fi tting. And press down on the battery until
it snaps into place.
6. Position the battery cover over the battery compartment.
Using a coin, press down and turn the cover in the
direction indicated “CLOSE” to position the knob of
the cover with the dot on the bottom case.
Replacing the internal clock battery
WARNING
• Be careful of handling a battery, as a battery can cause explosion, cracking
or leakage, which could result in a fi re, an injury, and environment pollution.
- Use only the specifi ed battery. Do not use a battery with damage, such as a
scratch, a dent, rust or leakage.
- When replacing the battery, replace it with a new battery.
- When a battery leaked, wipe the leakage out well with a waste cloth. If the leakage
adhered to your body, immediately rinse it well with water. When a battery leaked
in the battery holder, replace the batteries after wiping the leakage out.
- Make sure the plus and minus terminals are correctly aligned when loading a battery.
- Do not work on a battery; for example recharging or soldering.
- Keep a battery in a dark, cool and dry place. Never expose a battery to a fi re or water.
- Keep a battery away from children and pets. Be careful for them not to swallow a battery.
If swallowed consult a physician immediately for emergency treatment.
- Obey the local laws on disposing a battery.
√ Note
The internal clock will be initialized by removing the battery. For setting the clock, see the
“Network Guide”.
OPEN
CLOSE
OPEN
CLO
SE
OPEN CL
OS
E
CL
OS
E
CL
OS
E
OPEN CLOSE
Raised dot
Battery
Knob Battery
Cover