4
Introduction (continued)
EP8790NET
Components
The
EP8790NET
wireless network module is composed of its main unit (1) and rear cover (2).
(1) Main unit:
Mounts onto the
multimedea projector MP8790
.
(2) Rear cover:
Remove this cover when mounting the
EP8790NET
module to a projector and then
reattach once
the
EP8790NET
module is properly mounted onto the projector.
(3) Clasp:
Use this to secure the
EP8790NET
module in place. Tighten these once the
EP8790NET
module
is properly mounted
onto the projector.
(4) LAN port:
The port used to connect to a network hub or directly to a PC using a LAN cable. This
connection can't be accessed when the wireless LAN card is in use. Remove the wireless
LAN card if you wish to use a cable-based LAN connection. (Only one LAN connection at a
time is allowed.)
(5) PCMCIA card slot:
(6) Card eject button:
This is the slot for inserting the PCMCIA compatible wireless LAN card or memory cards.
Insert cards slowly and carefully into this slot. Use this button to remove a card from the card
slot. After pressing this button, slowly remove the card.
(7) Power cable:
Use this cable to connect the module to the projector in order to supply power to the module.
(8) Power port:
Firmly plug the power cable into this port after the module is properly mounted onto the
projector.
(1) Main unit
(4) LAN port
(5) PCMCIA card slot
(6) Card eject button
(2) Rear cover
(8) Power port
(7) Power cable
(3) Clasp
(9) Locking screws
3M™ Wireless Network Module EP8790NET
© 3M 2003. All Rights Reserved. 3M™ Multimedia Projector MP8790
