![background image](http://html1.mh-extra.com/html/3m/sp-se-2-1-1/sp-se-2-1-1_user-manual_3298346061.webp)
48
Locking setup or run mode
Setting secure run or secure setup (locking)
Models SE and DL
3. (Skip this step if securing setup and see step 4.) To set
Secure Run
Mode
, press
Enter
and “
0000
” will appear.
NOTE: if you want to set the code as “0000,” press Enter
repeatedly until “enabled” appears. This will be the unlock code.
Figure 4-10: Adding code for secure/lock screen
•
To select a numeric code, press
Up/Down
arrows to select a
number, press
Enter
to toggle between the fields.
•
Press
Enter
to
Enable
.
•
Press
On/Off/Esc
key to return to the
Start
screen. When you are
ready to run a session, press the Run/Pause key and the Secure
Run Mode prompt will appear. (See “Disabling secure run or secure
setup” below for details on stopping the run.)
Figure 4-11: Secure/lock run prompt
•
Selected value is shaded
•
Enter code by pressing up/down
arrows to change value
•
Press enter to move to each field
To unlock/unsecure
Press lock softkey and
then enter in code.
Summary of Contents for SP-SE-2-1/1
