3M SCOTT Vision C5, User Instructions

Page: 7 / 36

P/N 595390-01 Rev D 202009 7
SAFETY INFORMATION
Read all of the safety information before beginning any of the procedures in this User Instruction . The safety
information in this section is organized as follows:
•
“ All 3M Scott Fire & Safety Products ” on page 7
•
“ 3M Scott Full Facepieces ” on page 8
All 3M Scott Fire & Safety Products
The following safety directives apply to all 3M Scott Fire & Safety products.
•
Many 3M Scott Fire & Safety products are intended to support human life in hazardous atmospheres. Failure to
carefully read, understand, and follow the instructions and warnings in this User Instruction may result in serious
injury or death.
•
Improper use of this equipment may result in serious injury or death. Improper use includes, but is not limited to,
use without adequate training, disregard of the warnings and instructions contained herein, use of the equipment
for purposes not included in these User Instructions , and failure to inspect and maintain the equipment.
•
Apply only the instructions offered within this User Instruction . Maintenance procedures beyond the scope of this
User Instruction must not be performed. Additional disassembly may cause operation errors and/or component
failure and result in serious injury or death. If a discrepancy or malfunction cannot be corrected using the
procedures contained within this User Instruction , the product must be tagged to indicate that it is unserviceable
and referred to a 3M Scott Certified Technician II for evaluation and repair.
•
Comply with all User Instruction s and warnings contained in this and all applicable manuals and modules. While
an attempt has been made to address all foreseeable operating conditions, you must exercise careful judgment
when operating any equipment. If there is any doubt regarding the safe operation of equipment, remove the
equipment from service and tag it for repair.
•
You are responsible for any damage, improper function, or injury as a result of user-applied markings, etchings,
labeling, material additions, or modifications to the equipment.
P/N 595390-01
202009
Rev D