8
80-6111-841-1
4.3 Attach elbow connector on nozzle air hose firmly onto
the nozzle inlet.
Attach
90° elbow
connector
5.0 Using the 3M™ Scotchkote™ Spray System
HSS-450 Applicator
5.1 Point applicator upward and attach air supply hose to the
regulator. The air supply pressure should be 90–110 psi
(6.2–7.6 bar).
5.2 Purge cartridge and nozzle by first pointing the nozzle
up and pulling the trigger just long enough to fill the mix
nozzle with material; release the trigger before actually
dispensing material from the nozzle.
Second, point the nozzle into a waste receptacle and
dispense approximately a one-half nozzle-length of
potentially unmixed material.
Note: Do not open the ball valve until after the cartridge
and nozzle have been purged.
Note: Refer to Section 13 of the 3M™ Scotchkote™ Liquid
Epoxy Coating 323 Parts A and B MSDSs and applicable
regulations or authorities for waste disposal.
Attach Air
Supply Hose
5.3 Point the nozzle in a safe direction and open the ball
valve to start the air flow to the nozzle.
Open
