Remote, Sensors 2 and 3
Tri-sensor weighted average
053-664, Rev.C
QUESTempº 44 & 46 models
6
Remote, Sensors 2 and 3
The top sensor bar (sensor 1) may be removed from the instrument and used
through a remote cable. Shelter the instrument and remote the sensor bar if the
measured environment is expecting heavy rain or if temperatures are above 60
C.
The sensor 2 and sensor 3 jacks on the side of the instrument allow simultaneous
monitoring of up to three sensor arrays using connecting cables.
Cable lengths of up to two hundred feet (61 meters) may be used without a decrease
in accuracy provided the environment does not contain
strong electromagnetic fields.
The data from these arrays may be viewed separately or combined into a weighted
average WBGT reading per ISO 7243. Change the displayed sensor bar by pressing
and releasing the enter key. The upper right corner of the display shows the
current sensor bar. 1 refers to the top sensor bar, 2 and 3 are labeled on the side
of the unit, W indicates the weighted average which only appears if a WBGT is
displayed and all three of the sensor bars are attached.
Tri-sensor weighted average
Per the recommendations outlined in ISO 7243: 1989, when the temperature in the
space surrounding a worker is not uniform, it is necessary to determine the WBGT
index at three heights corresponding to the worker's ankles, abdomen and head and
perform a weighted average on those values. It is computed using the formula:
WBGTw = (WBGT head + (2 x WBGT abdomen) + WBGT ankles)/4
The QUESTemp
44/46 always assigns the top sensor bar the double weighting. This
calculation is shown if a WBGT display has been selected and if 3 sensor sets are
connected.
Remote
Sensors
