3M PROTEGE SG, Operation And Maintenance Manual

Page: 29 / 62

3M™ PROTÉGÉ SG
PORTABLE, REUSABLE, SINGLE-GAS MONITOR
CONFIGURATION AND SETUP
087-0065, Rev D/February 2019 4-5
4. The PGD Application Software dashboard will display, and the connected monitor is shown (see
Figure 4-7: Connected Monitors ).
Figure 4-7: Connected Monitors
4.4. Default Settings
Table 4-2: Factory Default Alarm Setpoints and Table 4-3: Firmware Default Settings provide the
default settings of the monitor.
NOTE: The user can configure alarm setpoints and the firmware settings via the PGD Appli-
cation software. Refer to the Portable Gas Detection (PGD) Application User Guide
(P/N 087-0061)
Table 4-2: Factory Default Alarm Setpoints
Gas Range TWA STEL Low High
Gas Type &
Value for CAL
O
2
0% -30% N/A N/A 19.5% 23.5% Zero air
H
2
S (Standard) 0 - 500ppm 10ppm 15ppm 10ppm 15ppm 25ppm H
2
S
H
2
S (High
Resolution)
0 - 100ppm 1ppm 5ppm 1ppm 5ppm 25ppm H
2
S
CO (Standard) 0 - 1000ppm 35ppm 200pp
m
35ppm 200pp
m
50ppm CO