5
Notice!
Never place ear muffs with humid foam on the helmet / hardhat! (4)
Notice!
100% use of a proper hearing protector is the only sure protection from hearing loss.
In environments with more than 82 dB A-weighted noise level, you need to protect your hearing. The hearing receptors in your inner-
ears may be irreparably damaged if you lift a cup of your hearing protectors for even a very short moment in a noisy environment.
The use of a comfortable hearing protector, designed for the specific noise level in which it is used, is the best guarantee to that you will
wear the hearing protector 100% of the time for to protect from permanent hearing loss.
For best protection, brush aside excess hair around your ears so the cushions fit snugly to your head.
Any temples/bands of spectacles or goggles should be as thin as possible to make the hearing protector fit close to the head.
MAINTENANCE
Clean the outside of the headset regularly with mild detergent and warm water.
Notice!
Do not immerse in water or fluids.
After prolonged hours of use, or other situations in which the Lite-Com Pro II attracts moisture inside the cups, remove the cushions
and inserts to allow the hearing protector to dry before next use.
Do not store the headset in temperatures exc55°C, for example on a dashboard or windowsill.
The headset (especially the ear cushions) can wear out over time. Inspect regularly for signs of any physical damage and replace if
necessary.
Certain chemical substances may be harmful to this product. Contact 3M for more information.
When the low battery warning alarm sounds, it is time to replace the batteries. The unit switches off automatically after a few minutes.
Never replace or install batteries with the unit switched on. Before switching on, make sure that the batteries are inserted correctly.
As with any hearing protector incorrect use or failure to the instructions supplied with this product could result in permanent disability
due to exposure to noise.
APPROVALS
MT7H7F4010-EU-50
Head Band Version
MT7H7B4010-EU-50
Neck Band Version
MT7H7P3E4010-EU-50
Version with attachment for use with hardhat
All models are identical, except for the band differences and the hardhat mounting.
Peltor Lite-Com Pro II headsets are ATEX and IECEx certified and approved by Nemko for use in hazardous locations.
CSA AND FM CERTIFICATION AND LISTINGS:
I M1 Ex ia I
II 2G Ex ia IIC T4
II 2D Ex ia IIIC T125°C
APPLICABLE STANDARDS:
CE
The Peltor Lite-Com Pro II is tested and approved as a hearing protector according to PPE directive 89/686/EEC and applicable
parts of the European EN 352-1:2002, EN 352-3:2002, EN 352-4:2001 and EN 352-6:2002 standards. Certified by FIOH,
Topeliuksenkatu 41, FI-00250 Helsinki, Finland ID#0403.
Measurements for products with a helmet attachment were performed on Peltor’s G22C hardhat.
The Lite-Com Pro II is also tested and approved according to the following standards:
Radio: ETSI EN 300,296-2, ETSI EN 300,296-1
EMC: ETSI EN 301,489-5, ETSI EN 301,489-1
The electrical measurements were performed by SP, the Swedish National Testing and Research Institute, Box 857, S-501 15
Borås, Sweden, ID# 0402.
WARNING:
Substitution of components may impair intrinsic safety.
Equipment with broken or otherwise damaged enclosure shall not be operated in the hazardous locations.
Use only 3M Peltor ACK08 battery!
Change batteries only in locations known to be non hazardous!
