3M™ MicroTouch™ Display C1500SS Installation Guide
11
3M Touch Systems Proprietary Information
CHAPTER 3
Setting Up Your C1500SS Display
This chapter describes how to set up and integrate your 3M Touch Systems C1500SS
Display into a touch application. You need to complete the following tasks:
•
Unpack the components
•
Connect the video, touch sensor, and power cables
•
Power on the display and test your setup
•
Install the touch software
•
Calibrate the touch sensor
System Requirements
The C1500SS Display requires a personal computer (PC). These touch displays are not
supported on Macintosh computers.
The requirements for your PC are as follows:
•
Your PC must have an available RS-232 serial communication (COM) or USB port.
You connect the touch sensor to this port.
•
Your PC must have a unique interrupt request (IRQ) available to the COM port that
the touch sensor will use. The touch sensor cannot share an IRQ with another device.
•
Your PC must have a video card and video driver already installed for the display. If
you need to install a video card or a video driver, refer to your computer
documentation for instructions.
When choosing your workspace, select a sturdy, level surface. Also, make sure you can
easily access the back of the touch display and the computer. Easy access helps ensure a
smooth setup of the touch display.
Note:
Before setting up your C1500SS Display, refer to the “Important Safety
Information” section at the beginning of this document.
Unpacking Your Touch Display
Carefully unpack the carton and inspect the contents. Your C1500SS includes the
following cables and accessories:
•
SVGA video cable
Summary of Contents for MicroTouch CT150
Page 16: ......