8
78-81
41-4631
-
8
-
A
2.2.2 Apply a tape marker to semi-con insulation shield on
cable which does not contain splice.
Measure 10
1/2
" (2
67
mm) from center of connector.
10
1/2
" (2
67
mm)
2.2
Install Splice
2.2.1 Install connector. See table (on cover) for proper
connector dimensions. (For standard 3M
™
connectors,
refer to table at the end of this instruction for crimping
information)
2.2.3
If using cold shrink adapter tube:
Position adapter tube over the connector. Shrink adapter
near center of connector by pulling and unwinding the
loose core end.
2.1.5 For 1/0 through 3/0 AWG connectors, or
connectors with an O.D. between 0.51-0.76"
(13,0–19,3 mm): Slide the cold shrink adapter tube
with the WHITE CORE onto the insulation with the
loose core ribbon end going on first, away from the
cable end.
For 4/0 AWG through 350 kcmil connectors or
connectors with an O.D. between 0.68–1.07"
(17,3–27,2 mm): Slide the cold shrink adapter tube
with the RED CORE onto the insulation with the loose
core ribbon end going on first, away from the cable
end.
