3M 3R108-0000-000CE, Assembly Instructions

Page: 2 / 4

2
80-4000-7019-1
3M
™
Industrial RJ45 Modular Plug for Ethernet, Assembly Instructions
3.0 Cable Prep
3.1 Slide case module onto cable. (Figure 2)
Figure 2
3.2 Trim outer jacket approximately 50 mm. (Figure 3)
Figure 3
3.3 Fold back braided shield or drain wire and remove foil shield.
(Figure 4)
Figure 4
3.4 Attach conductive tape over the braided shield or drain wire at the
edge of the cable jacket. Trim off excess braid. Add spacers onto
the cable if necessary. Be sure no braided shielding comes out of
the end of the conductive tape. (Figure 5)
Figure 5
4.0 Termination Process
4.1 Set cable onto the cover module so the conductive tape fits
into the ground. (Figure 6)
Figure 6
4.2 Attach cable clamp so the wiring diagram image matches the
connector. (Figure 7)
Figure 7
4.3 Remove the wiring diagram and fasten screws with a screwdriver.
Make sure the cable is firmly secured and there are no gaps
between the modules. (Figure 8)
Figure 8
4.4 Place wires into the slots of the cover module following the wiring
diagram. There is no need to untwist the wires.
Confirm that the wires are positioned and secured at the bottom of
the slots. (Figure 9)
Figure 9
4.5 Place the body module onto the cover module in a parallel fashion.
(Figure 10)
Figure 10