3
•
Failure to install or operate your filter system in accordance with these use instructions or any
other installation or use instructions accompanying this product may result in product failure and
property damage, including water leakage and will void warranty.
To reduce the risk associated with property damage due to water leakage or flooding:
•
Read and follow
allInstructions before installation and use of this system.
• Installation and Use
MUST
comply with all state and local plumbing codes.
•
Protect from freezing
, remove filter cartridge when temperatures are expected to drop below 40° F (4.4° C).
•
Do not
install systems in areas where ambient temperatures may go above 110° F (43.3° C).
•
Do not
install on hot water supply lines. The maximum operating water temperature of this filter system is 100°F (37.8°C).
•
Do not
install if water pressure exceeds 100 psi (689 kPa). If your water pressure exceeds 80 psi, you
must
install a
pressure limiting valve. Contact a plumbing professional if you are uncertain how to check your water pressure.
•
Do not
install where water hammer conditions may occur. If water hammer conditions exist you must install a water
hammer arrester. Contact a plumbing professional if you are uncertain how to check for this condition.
• Where a backflow prevention device is installed on a water system, a device for controlling pressure due to thermal
expansion must be installed. Contact a plumbing professional if you are uncertain how to select/install/maintain a
thermal expansion device.
• Where a booster pump is installed on a water system, you must maintain and inspect the attached pressure switch
regularly in accordance with the booster pump manufacturer’s instructions. Contact a plumbing professional if you
are uncertain how to maintain your booster pump system.
• Where a booster pump is installed on a water system, you must install an appropriate pressure relief valve. Pres
-
sure relief valve must be maintained and inspected every 6 months. Contact a plumbing professional if you are
uncertain how select/install/maintain a pressure relief valve.
•
Do not
use a torch or other high temperature sources near filter system, cartridges, plastic fittings or plastic plumbing.
•
Do not
install system where water lines could be subjected to vacuum conditions without appropriate measures for
vacuum prevention.
• On plastic fittings, never use pipe sealant or pipe dope. Use PTFE thread tape only, pipe dope properties may dete
-
riorate plastic.
• Take care when using pliers or pipe wrenches to tighten plastic fittings, as damage may occur if over tightening occurs.
•
Do not
install in direct sunlight or outdoors.
•
Do not
install near water pipes which will be in path of a drilling tool when selecting the position to mount the
bracket.
• Mount filter in such a position as to prevent it from being struck by other items used in the area of installation.
• Ensure that the location and fasteners will support the weight of the system when installed and full of water.
• Ensure all tubing and fittings are secure and free of leaks.
•
Do not
install unit if any fitting if collet is missing. Contact 3M if collets are missing from any fittings.
To reduce the risk of water leakage or flooding, and to ensure optimal filter performance:
• Change the disposable filter cartridge every 12 months or sooner if you observe a noticeable reduction in water flow rate.
• Change the disposable filter membrane every 36 months or sooner if you observe a noticeable reduction in mem
-
brane production rate.
• Failure to replace the disposable filter cartridges & membrane at recommended intervals may lead to reduced filter
performance and cracks in the filter housing, causing water leakage or flooding.
• For questions or concerns, please contact Customer Service at 1-855-3M-WATER.
NOTICE
