3M 33573, Operator’S Manual & Safety Instructions

Page: 11 / 114

9 Translation of Original Instructions
GENERAL SET UP AND USE:
• Read all instructions before using this tool . All operators must be fully trained in its use and aware of all safety rules . All service
and repair must be carried out by trained personnel .
• The tool RPM should be checked on a regular basis to ensure proper operating speed .
• Make sure the tool is disconnected from the air supply and then attach 3M abrasive belt to the sander . Always wear required
safety equipment when using this tool .
• When sanding always start the tool just prior to contacting the work piece . Stop air flow to the tool as it is removed from the
work piece .
• Always remove the air supply to the sander before fitting, adjusting or removing the abrasive .
• Use only 3M approved parts .
• Prior to installing any File Belt Sander accessory, always check that its marked maximum operating speed is equal to or higher
than the rated speed of this tool .
SETTING & TESTING TOOL SPEED:
1 . Ensure the Trigger is not depressed
2 . Connect the compressed airline
3 . Press the Trigger slowly and increase force until tool is at full speed
4 . Use a Rotary Tachometer to check the speed
5 . Check speed regularly