13
5.4 PRODUCT LIFE:
The functional life of Nano-Lok SRLs is determined by work conditions and maintenance.
As long as the SRL passes inspection criteria, it may remain in service.
5.5 DISPOSAL:
Dispose of the Nano-Lok SRL if it has been subjected to fall force, or an inspection reveals an
unsafe or defective condition. Before disposing of the SRL, cut the Load Indicator off of the Web Lanyard or
otherwise disable the SRL to eliminate the possibility of inadvertent reuse.
6.0 MAINTENANCE, SERVICING, AND STORAGE
6.1 CLEANING:
Cleaning procedures for the Nano-Lok SRL are as follows:
• Periodically clean the exterior of the SRL using water and a mild soap solution. Position the SRL so
excess water can drain out. Clean labels as required.
• Clean the Web Lifeline with water and mild soap solution. Rinse and thoroughly air dry. Do not force dry
with heat. The lifeline should be dry before allowing it to retract into the housing. An excessive buildup
of dirt, paint, etc. may prevent the lifeline from fully retracting back into the housing causing a potential
free fall hazard.
IMPORTANT:
If the lifeline contacts acids or other caustic chemicals, remove the SRL from service
and wash with water and a mild soap solution. Inspect the SRL per Table 1 before returning to
service.
6.2 SERVICE:
Nano-Lok SRLs are not repairable. If the SRL has been subjected to fall force or inspection
reveals an unsafe or defective condition, remove the SRL from service and discard (see
“Section 5.5 -
Disposal”
).
6.3 STORAGE:
Store Nano-Lok SRLs in a cool, dry, clean environment out of direct sunlight. Avoid areas where
chemical vapors may exist. Thoroughly inspect the SRL after any period of extended storage.
7.0 SPECIFICATIONS
7.1 PERFORMANCE:
Your Nano-Lok SRL has been tested and certified to the performance requirements
of the standard(s) identified on the cover of this instruction manual. See
“Section 2.0 - Limitations &
Requirements”
for performance specifications.
7.2 MATERIALS:
Material specifications for the Nano-Lok SRL are as follows:
Housing:
Nylon, UV Resistant
Motor Spring:
Stainless Steel
Drum:
Nylon, Type 6/6
Swivel:
Zinc Plated Steel
Fasteners:
Zinc Plated Steel Screws; Stainless
Steel Rivets
Lifeline:
Dynema Polyester Web,
Hot Work
Kevlar Nomex Web
Locking Pawls:
Stainless Steel
Load Indicator
Cover: Denier Textured Nylon
Stitching: Polyester or Nylon Thread
Web: Polyester
Main Shaft:
Stainless Steel
Hot Work
Cover: Kevlar Nomex
Stitching: Nomex
Web: Kevlar Nomex
End
Connectors:
See Figure 18 for End Connector options and their respective material specifications.
7.3 DIMENSIONS:
Figure 18 lists Nano-Lok SRL dimensions. Average working range for the Nano-Lok SRL is
6 ft. (1.8 m), but will vary slightly with length differences in the various End Connector options. Retracted
and Extended length values in Figure 18 are approximations based on the total length of the fully retracted/
extended SRL and the applicable End Connectors.
7.4 LABELING:
Figure 19 illustrates Nano-Lok SRL labeling. All labels on the SRL must be present and fully
legible.
Summary of Contents for 3101220
Page 16: ...16 Figure 19 Labeling ...
Page 17: ...17 Figure 19 Labeling ...
