3M 11600, Instructions And Parts List

Page: 36 / 176

NA - ENG
April 2016
3M-Matic ™ 8000a-8000a3
Page 24
11.1 Box Width Adjustment
Place a product fi lled box on infeed
end of machine bed with top fl aps
folded as shown and manually move
box forward to contact lower taping
head applying roller.
Turn drive belt adjustment crank to
position both side drive belts against
sides of box (Figure 11-1).
11.2 Box Height Adjustment
Turn height adjustment crank
to position upper taping head onto
box. Turn clockwise to lower head,
counterclockwise to raise head.
Upper taping head must contact
and hold top box fl aps closed
(Figure 11-2).
11.3 Adjustment of Top Flap
Compression Rollers
The top fl ap compression rollers
have an adjustable slide mounting
to provide side compression through
the full range of box widths.
Manually move box forward so
front of box is aligned with top fl ap
compression rollers.
Adjust the compression rollers
against top edge of box and tighten
knobs to secure rollers in operating
position (Figure 11-3).
11.4 Changing the Tape Leg Length
Taping heads are preset to apply
70mm [2.75 inches] long tape legs.
To change tape leg length to 50mm
[2.0 inches], refer to Instructions
below and also to Manual 2,
“Removing Taping Heads Procedure -
Changing the Tape Leg Length”.
11. Set-Up and Adjustments
Figure 11-3
Figure 11-1
Figure 11-2