Installation
Remove Face Panel
3-60-765 Power Supply
16' Cable
Section View
Overall View
Wall
1¼"
unpackage LightBox and remove the face panel. The face panel is affixed to the LightBox with 3M Dual Lock tape. The LightBox is
shipped with shims behind the face panel to prevent the Dual Lock from engaging. Once the Dual Lock is engaged, it will require
prying the face out with a thin flat screwdriver. Being careful not to scratch the frame or face, pry the face out starting in one
corner and then pull the face out.
Fasten LightBox to the wall. A
standard 48" � 48" LightBox
weighs about 75 lbs., so blocking
or attachment to studs is
recommended. The LightBox
comes from the factory with (8)
1/4" pre-drilled mounting holes
through the frame at 9" from
each corner.
Additional mounting holes can
be drilled through the frame
along the drill guide lines. use
appropriate wood screws or
anchors depending on the
mounting substrate. #10 or 3/16"
diameter fasteners are
recommended.
Determine where the LightBox will be mounted and remote location for the power supply. Hardwire the power supply to line
voltage and connect to the provided 16' cable. If the power supply must be mounted more than 16' from the LightBox, the wires
can be extended up to 50' using minimum 18 AWG wire. (See the Wiring Diagram on page 5 and Dimming Wiring Diagrams
on page 5 - page 6)
Hardwire
Fasten To Wall
3
For more information, please visit 3-form.com or call 800.726.0126
JunE 2018 | MAn-020 Backlighting - LightBox | REV 009 © 2018 3form, Inc. All rights reserved.
