Instructions
Cover
Extrusion
Remove top end cap
for access to snap
off cover extrusions
Drill Ø 1/4" holes
along drill guide lines
in base extrusion
Attach to wall with appropriate
3/16", 1/4", or M6 anchors
depending on wall surface.
2"
Section View
Fin Panel
Base Extrusion
Cover Extrusion
Cover Extrusion
Anchor
Installation is basically the same for all Fins. The only
difference is the orientation and substrate that the Fin
will be mounted to.
The Fin Panels will come assembled from the factory.
The cover extrusions may be shipped loose or in-
stalled at the factory. If they are installed you will need
to remove them to fasten the fin to the wall. Remove
the top end cap and slide a screwdriver or thin rod
between the cover and base near the top. Pry outward
to snap off covers.
The Fin Panel may be removed for installation to
prevent scratching or damage if desired. Remove the
nuts and bolts fastening the Fin Panel and pull it out of
the channel.
Mounting holes are not pre-drilled at the factory in
the base extrusion. This will allow hole placement to
match structure on site such as studs or furring strips.
Drill Ø 1/4” holes on both sides of base extrusion along
drill guide lines. Holes should be spaced no more
than 30” apart and no more than 12” in from the top/
bottom.
Fasten the Fin Panel to the structure using appropriate
anchors for the substrate. Recommend 3/16” � 1-3/4”
long wood screws for wood and 3/16”, 1/4”, or M6
anchors for concrete or cement.
Re-install the Fin Panel if it was removed and snap the
cover extrusions in place.
Connect cable to power supply or controller.
See 3flex Series Edge Lighting Solution Document for
wiring specifications and diagram.
Installation
Installation Manual
7
For more information, please visit 3-form.com or call 800.726.0126
JULY 2016 | MAN-052 Fin | REV 004 © 2016 3form, Inc. All rights reserved.
