3
EN
11/2023
STEP 2:
Load and extrude
plastic
STEP 3:
Doodle your name
Use the box on page 4 to
create your first Doodle!
Insert the spool into the
plastic loading port.
Select a spool (included in
the box).
After 10-15 seconds, plastic
will begin extruding from the
nozzle. Extruded plastic will
harden after a few seconds.
Click either speed button
once to stop extruding.
Wait for the LED light to turn
GREEN/BLUE. Click the FAST
button once and release. You
will hear the drive gear start.
3
4
2
5
SECTION 2: GETTING STARTED
SECTION 2: GETTING STARTED
1
x1
Write your name in the box
provided using a marker, pen
or pencil. We suggest cursive,
with the letters connected.
Trace your name in a continuous
line by dragging the pen along
the paper as if you were writing
with a pencil, with all the
letters connected. Keep your
movement slow and steady.
For best results, hold the pen at
close to a 90˚ angle.
Wait for the material to cool
and then bend the corners
of your paper to pop your
doodled name off the page.
Click either speed button once. When the plastic starts
extruding, press the nozzle down onto paper to get the plastic
to stick to the surface.
When you are done, stop
extruding by clicking either
speed button once.
1
3
5
2
4
NOTE:
The pen tip must make contact
with the paper for it to stick.
