®
3Doodler 2.0
WARNINGS & NOTICES
ENGLISH
USING YOUR 3DOODLER 2.0
Step 1:
Connect your 3Doodler 2.0 to the power adapter
Connect the power adapter to the back of the 3Doodler and plug it
into a power source.
Note: If you have also purchased the 3Doodler JetPack
®
you
can also connect this to the back of the 3Doodler as a power
source.
Actual product may vary from the image found in this document.
LED LEGEND:
Solid RED:
Heating up
(please wait)
BLUE:
ABS
(230°C to 240°C;
446°F to 464°F)
GREEN:
PLA
(190°C to 200°C;
374°F to 392°F)
Flashing LED:
Reversing plastic
2
1
3
4
9
11
10
7
14
12
5
6
Step 2:
Turn on the pen and select
your plastic/filament
Turn the pen on by selecting the correct
heating temperature for the type of
plastic/filament you are using. Set the
slide switch to HI (“High”) for high
temperature plastics/filaments like ABS or
FLEXY, or LO (“Low”) for low temperature
plastics/filaments like PLA.
HI
LO
OFF
8
13
®
3Doodler 2.0
WARNINGS & NOTICES
ENGLISH
BLUE = HI (“HIGH”) ABS and FLEXY
(heating range
between 230°C and 240°C; or 446°F and 464°F)
GREEN = LO (“LOW”) PLA
(heating range between
190°C and 200°C; or 374°F and 392°F)
Step 3:
Allow your 3Doodler to heat up before loading
plastic/filament
The 3Doodler takes approximately 2 minutes to heat up. During
that time the LED indicator will be
RED
and it will not be possible to
use the pen. Once the correct melting temperature is reached and
the pen is ready, the LED indicator will change to
BLUE
(HI) or
GREEN
(LO).
Step 4:
Load the pen
Load the plastic/filament into the plastic loader at the back of
the pen, feeding it down the length of the 3Doodler until you feel it
gripped by the gears inside the pen.
It can take up to 30 seconds
for a newly loaded strand to begin extruding from the nozzle of
the pen.
NOTE:
If you do not feel the plastic/filament being gripped
by the gears inside the pen, please give the plastic a
gentle clockwise twist while pushing it down the shaft of
the 3Doodler.
12
12
Plastic/filament
NOTE:
After 5 minutes of inactivity the 3Doodler’s heating
system will automatically power down. You will need to
press one of the buttons OR toggle the slide switch off
and then on again to continue use.
Step 5:
Extrude/select your speed
Simply
single-click
on the desired
extrusion speed (
FAST
(3) or
SLOW
(4) )
and your 3Doodler will continuously
extrude plastic/filament for up to ten
minutes before stopping.
To stop the continuous flow of
plastic/filament, simply click on either the
FAST
(3) or
SLOW
(4) button on your
3Doodler.
If the pen stops and the
RED
LED appears again, wait a moment
for the LED to change to the appropriate color again (the pen is
simply returning to its optimal heating temperature).
2
3
2
3
2
3
