5
EXTRUDER
Figure 5.12: Installing the X-axis belt clamp on the right
•
Cut the GT2 timing belt loop to one straight line section. Clamp down the belt on
one end, pass it around the X-axis idler and the GT2 pulley, and clamp down the belt
on another end (Figure 5.13). Before tightening the clamps, straight the belt up and
cut off extra length on the end. (
Note: The belt only needs to be straight up in this
step, and it will be tightened up by sliding the X-axis motor in a later step.
)
Figure 5.13: Installing the X-axis GT2 timing belt
•
Adjust the GT2 pulley on the X-axis motor shaft to align the GT2 timing belt from
end to end. (Figure 5.14)
79
Summary of Contents for Artifex 2
