page
16
... print your plane | www.
3DLabPrint
.com
5.2.1 Fuselage assembly VL Pyörremyrsky
You can use snap knife for cleaning the surface of printed parts, but mostly it is not necessary.
Glue fuselage parts F1-F4 with CA glue together. The new 3DLabPrint lock system will help you.
Zkontrolujte kolmost dílu F4 na uložení křídla dílů F1 a F2 před zalepením. Do not glue rudder
part before tail and elevator assembly. Use any hot tool to remove the unnecessary material
from F4 tail part for the elevator arm.
Insert two 90 mm long 3 mm diameter carbon rods making a rubber band wing holders. No
need to glue it for easy replacement.
For fuselage cover arm use a ball pen spring. Put it to the part 2 and glue with part 1 together.
NOTE: Don‘t glue the rudder tailpart yet !!! (proceed to the next step for elevator and stabilizer
assembly)
+
Snap knife or Sandpaper, Soldering Iron or any hot tool + hot glue
2x 90mm of 3mm carbon or fiberglass rod
F1
24g/0.84oz LW
F2
19,4g/0.68oz LW
F3
12,5g/0.44oz LW
F4
9,2g/0.32oz LW
ball pen spring
motor mount
6,5g/0.23oz PLA
spinner
4,8g/0.17oz PLA
cover 1
3g/0.10oz LW
cover arm
1g/0.03oz LW
2,8g/0.10oz PLA
cover 2
4,3g/0.15oz LW
