3D Systems sPro, User Manual

Page: 61 / 280

SLS p r o c e s s 6 1 P R E P A R E T O B U I L D
u s e r ’ s g u i d e s t a r t i n g t h e e q u i p m e n t
L
To save time, connect the RCM now and begin
preheating it, then continue starting the other
equipment. See
Preheating the RCM on
page 68.
SLS system start-up
L
If the O2 alarm monitor is off (AC power light on
front is off ), open the hinged panel to access
the power switch, then switch power ON. For
more information, see the separate
Oxygen
Alarm Monitor Operating Instructions that
came with your system.
Perform the procedures below to start up the SLS
system from its powered-off state:
`
Power on the SLS system
`
Run the Sinter application
`
Perform SLS system machine start-up
sequence
These three procedures are described next.
POWER-ON SLS SYSTEM
1
Turn on the SLS
system’s main
power disconnect
switch on the AC
chassis door (at left
rear of SLS system).
2
Turn on SLS system
UI monitor. The
power button is at
top left rear corner
of the monitor,
along with the other display adjustment
buttons.
L
The SLS system computer powers up when
you turn on the main power disconnect.
You don’t need to turn it on separately.
Before you power on the SLS system
or open the N2 generator air supply
valve, verify that the room O2 alarm
monitor is ON and that the O2 alarm
cable is properly connected to the
SLS system gauge panel.
See SLS System Features
on page 182 to locate
the switches in this
startup procedure. Also
see
Starting the SLS
System (only) on
page 191. The SLS
system connects to 208
VAC, 50-60 Hz, 3-phase
WYE facility power.