3D Systems sPro, User Manual

Page: 36 / 280

SLS p r o c e s s 3 6 S A F E T Y
u s e r ’ s g u i d e D u r a F o r m m a t e r i a l h a n d l i n g s a f e t y
D u ra Fo r m M at e r i a l H a n d l i n g S a fe t y
Emergency (MSDS)
ChemtrecUSA
(800) 424-9300 ;
Europe +1-703-527-3887
Packaging Inspection
DuraForm material is packaged in the Intelligent
Powder Cartridge ( IPC ). Upon receipt of a
material shipment, inspect the IPC for signs of
physical damage and evidence of leakage by
inspecting the exterior. If leakage or damage is
observed,
do not connect the IPC to the
Integrated Recycling Station ( IRS ), and contact
3D Systems Customer Support Hotline . If no
leakage or damage is observed, store the full IPCs
safely according to the
storage guidelines below
until you need to refill your IRS.
Storage
The shelf life of DuraForm PA model material is
one year from date of manufacture. Each IPC is
tagged with its expiration date. Use the oldest
IPCs first. DuraForm material should be kept
indoors in a cool, dry area with adequate
ventilation, and at temperatures between 16°C
(60°F) and 27°C (80°F). DO NOT EXCEED A
MAXIMUM STORAGE TEMPERATURE OF 35°C
(95°F). Keep away from direct sunlight, heat,
flames and other direct light or UV energy
sources.
Never try to open an IPC. Material
must only be removed from the IPC
through the IRS umbilical.