3D Systems sPro, User Manual

Page: 210 / 280

SLS p r o c e s s 2 1 0 B O S
u s e r ’ s g u i d e B O S o v e r v i e w
B O S O ve r v i ew
When a build is complete, you need to remove
the sintered parts from the RCM part cake and
clean them. Removing parts from the part cake is
called “breakout.”
To remove parts from a part cake, you roll the
cooled RCM into the BOS, connect the RCM cable,
and gradually raise the part piston, removing
powder and parts as you go. Unsintered part cake
powder goes into the BOS powder transport
hopper where it is sifted and either recycled back
to the IRS, or disposed of.
L
You can find material-specific information
about breaking out and cleaning parts in your
Material Guide .