3d-printz Nice 2000, Manual

Page: 6 / 6

Battery: 3S Lipo, 2200mah, 25C
Motor:
Racerstar BR2212 1400KV
...or similar
ESC: any Micro ESC with BEC, 20A (make sure to choose a small one)
Prop: Foldingprop 8.5x7.5 (you can choose a
printable one)
Throws
With the recommended CG at 50mm behind the leading edge you can use these
throws as a basic setup:
Aileron: +/- 20mm
Elevator: +/- 10mm
Rudder: Maximum
Camber (Thermik): -3mm
Speed: +2mm
Butterfly/Crow:
Flaps -25mm
Ai20mm
Elevator -2mm
Please test the Butterfly/Crow in a good height before you try to land with it!
Center of Gravity
The right center of gravity is essential for comfortable flight behavior. This is
precisely why it should be dialed in individually. The initial value can be assumed to
be approx. 50 mm behind the leading edge. If more performance and more agile
flight behavior is desired, the center of gravity can be shifted further back, but the
throws should then also be adjusted.
Please note that the center of gravity and the throws have to be chosen by the pilot
himself for each Nice built - the values given here are only guidelines!
We wish you a lot of fun with your Nice!