3dmoleculardesigns.com
. . .where molecules become real
TM
Contents and Assembly Directions - Page 2
©
Copyright 2002, 2013. All rights reserved.
Assembling 3D Water Molecules
Take one red piece in each hand. You will see one post and one
hole on the inside rim of each red piece.
Position the post of one piece into the hole of the other piece. Place your thumbs
on the flat surface of each oxygen piece, and push the two pieces together until
they fit tightly and you no longer see a space between the pieces.
The red oxygen atom will now roughly resemble a sphere with two knobs sticking
out of each half.
Take the red oxygen atom in one hand and one white hydrogen piece
with a
magnet
in the other and place the open side of the hydrogen piece onto the
knob on the oxygen.
Push the two together until the hydrogen fits tightly onto the oxygen, with no
space between the two pieces.
Repeat with a second white hydrogen piece
with a magnet
.
You now have one complete water molecule model. Repeat steps 1 through 6,
until 12 water molecule models are assembled.
Start by selecting two red oxygen pieces and two white hydrogen pieces
with magnets
.
Assembly directions continued on page 3
Hydrogen with
magnet
