Rudder pull-pull linkage
Install rudder servo in fuselage as shown. We are using a 2” double servo arm. Install the servo arm as
close to perpendicular as possible. Then use your radio's subtrim as needed.
The rudder pull-pull cables are assembled as shown in the above diagram.
Assemble end of pull-pull wire as shown, double-looping the wire through the brass crimp sleeve
before crimping. Crimp the brass crimp sleeve tightly with pliers and apply a drop of thin CA to the
crimp. Install the ball links onto the rudder horn using the 2mm bolt (screw), washer and lock nut.
Assemble rudder servo arm with servo connectors as shown. Be sure that the connectors are free to
rotate on the arm, and use medium or thick CA to lock the nuts.
NOTE: the pull-pull cables cross over once inside the fuselage, forming an “X”
17
