Adding UPS Support to an Existing VCX System
127
Requirements
Setting up a VCX system to use UPS power and to monitor UPS status
using the
vcx-ups-setup
command requires the following configuration
information for each UPS in the VCX system:
■
IP address of the UPS — You must know the pre-configured IP address
assigned to the UPS.
■
SNMP community string — You must know the pre-configured SNMP
write community string assigned to the UPS.
■
Low battery threshold percentage — You must specify the battery
charge level (expressed as a percentage of battery capacity) at which
point the attached server (or servers) should initiate a shutdown.
You must also supply the following information for each VCX server:
■
Whether a server is the master or a slave
■
On each slave server, the IP address of the master VCX server
Adding Single UPS
Device Support
This section describes how to configure a VCX system supported by a
single UPS. Depending on your VCX configuration, this requires one or
two general steps:
■
If your VCX system includes a single VCX server, configure that system
as the master.
■
If your VCX system includes multiple VCX servers, configure one server
as the master and the remaining servers as slaves.
Single UPS System – Configuring the Master VCX Server
To initially enable and configure a VCX server as the master in a single
UPS system:
1
Log in, using the
root
account, to the VCX server you want to designate
as the master.
2
Enter the following command:
vcx-ups-setup <configuration_parameters>
You must concatenate the following
vcx-ups-setup
command
configuration parameters (responses are shown in bold):
-- master:
Y
Enter
Y
(you must uppercase) to designate this server as the master.
-- monitormultipleups:
N
Summary of Contents for VCX V7000
