3Com PathBuilder S200 Series, Manual

Page: 14 / 31

10 Voice Over IP
VoIP Applications
Configuration Figure 9 shows the parameters configured for each PathBuilder S200 series switch.
Figure 9. Configurable Parameters to support VoIP
Voice Port Configuration
Port Number: 31
Port Type: Voice
Interface Type:FXS
Signalling Type: 1
E Lead Filter: Disable
Signalling Mode: Normal
Signalling Control: Immediate
PCM Mode:
µ
law
Compression Rate: 8K
DSI Control: Enable
Smoothing Delay: 80 msec
Input Signal Level: 0dBm
Output Signal Level: 0dBm
Fax Support: Enable
Call Control: Switched
Ethernet Port Configuration
(Configure for both nodes)
Port Number: 4
Port Type: ETH
LAN Cable Type: AUI
Port MAC Address: 00-00-00-00-00-00
Transmit Queue Limit: 50
Carrier Sense Filter:0
Collision Detect Filter: 0
PB S200 Interface Number: 1
IP Network
Node 100 Node 200
PBX
Voice
Port LAN
Port LAN
Port Voice
Port
Node Record
Nodename: Node100
Node Address: 100
Maximum Routing Hops:15
Maximum Routing Hops for Voice:2
Voice Switching Table Size: 16
Node Record
Nodename: Node200
Node Address: 200
Maximum Routing Hops:15
Maximum Routing Hops for Voice:2
Voice Switching Table Size: 16
Voice Port Configuration
Port Number: 31
Port Type: Voice
Interface Type: FXS
Signalling Type: 1
E Lead Filter: Disable
Signalling Mode: Normal
Signalling Control: Immediate
PCM Mode:
µ
law
Compression Rate: 8K
DSI Control: Enable
Smoothing Delay: 80 msec
Input Signal Level: 0dBm
Output Signal Level: 0dBm
Fax Support: Enable
Call Control: Switched
Configure PB S200
Interface State
(Configure for both nodes)
Interface #1 State: Enabled
IP Interface Configuration Table
Entry #: 1
Interface Number: 1
IP Address: 150.20.35.1
IP Address Mask: 255.255.255.0
Accept RIP: Enabled
IP Interface Configuration Table
Entry #: 1
Interface Number: 1
IP Address: 150.20.35.2
IP Address Mask: 255.255.255.0
Accept RIP: Enabled
Node 200
Route Selection Table
Entry # 1
Address: 100
#1 Destination: SOTCP
#1 Priority: 1
Node 100
Route Selection Table
Entry # 1
Address: 200
#1 Destination: SOTCP
#1 Priority: 1
Node 200
SoTCP Map Table
Entry # 1
Destination X.25 Address: 100
Next hop IP Address: 150.20.35.1
Node 100
SoTCP Map Table
Entry # 1
Destination X.25 Address: 200
Next hop IP Address: 150.20.35.2
SoTCP Parameters (Configure for both nodes)
TCP Port Number: 1099
Max. No. TCP Sessions: 10
Max. SVCs per session:1
Max. Total SVCs:10
Serial Connection establishment timeout: 100
TCP Connection establishment/clearing timeout: 200
TCP Keep alive timer: Disabled
Node 100
Voice Switching Table
RX DTMF Digits: 3W
No. of RX Digits: 3
Call Parameter 20031
Node200
Voice Switching Table
RX DTMF Digits: 3W
No. of RX Digits: 3
Call Parameter 10031