Installing The Internet Firewall
Start by placing your Internet Firewall on a hard, flat surface near your cable modem, DSL modem
or Internet router.
Note:
The
Internet Firewall 25
front and rear panel views differ from those of the
Internet Firewall
DMZ
below. The same instructions, however, apply to both models.
Connect the Internet Firewall to Your Network
Connect an Ethernet cable to the Internet Firewall's
LAN
port. Connect the other end to your LAN hub.
2
Apply Power to the Internet Firewall
Attach the power adapter to the power adapter
socket on the Internet Firewall and plug the other end
into a power outlet.
The Internet Firewall's
Power
LED will flash for
approximately 90 seconds as it performs a series of
diagnostic tests.
3
Check Link LEDs
The
WAN Link
LED, the
LAN Link
LED on the
Internet Firewall should light up.
If the
Link
LED on the
LAN
port does not light up
after applying power, press the
Uplink/Normal
switch located next to the
LAN
port.
4
1
Connect the Internet Firewall to the Internet
Attach the Internet Firewall's
WAN
port to your cable
modem, DSL modem or Internet router, using the
Ethernet cable. After you apply power, verify that the
Link
LED on the Internet Firewall's
WAN
port is lit.
