3Com NETBuilder II, Installing Instruction, Page: 34 / 82

2-6 C
HAPTER
2: NETB
UILDER
II 8-S
LOT
B
RIDGE
/R
OUTER
3 Verify that the configurable parameters of your device match the configuration
settings of the CONSOLE port specified in Table 2-1.
4 Turn on the PC, terminal, or modem.
Connecting the
Power Cord
A power cord is supplied with all NETBuilder II chassis. If the power cord does
not match your requirements, contact your network supplier for assistance.
The AC power switch is marked according to international I/O convention:
When you press the I side, the switch is on; when you press the O side, the
switch is off.
Make sure the power switch is turned off (O), and plug the power cord into the
AC power receptacle on the back of the unit.
Table 2-1 CONSOLE Port Configuration Settings
Characteristic Setting
Baud rate 9600
Databits 8
Parity None
Stop bits 1
DTR Ignored
Duplex Full
Echo Off
Flow control X-on/X-off