3Com NETBuilder II DPE 80, Manual, Page: 13 / 32

Installing Software 1-7
3 Verify that configurable parameters of your console match the configuration
settings of the CONSOLE port specified in Table 1-1.
4 Turn on the console.
Installing Software
If you have bought the software from 3Com preinstalled on a flash memory
card, insert the card into drive A, the top flash memory drive. The default boot
and configuration file paths are to a directory on drive A.
Refer to the release notes for approved vendors of blank flash memory cards for
backup. The software guide describes how to format a blank card.
For information about configuring the NETBuilder II software, refer to the
software guides that shipped with your software package.
Table 1-1 CONSOLE Port Configuration Settings
Characteristic Setting
Baud rate 9600
Databits 8
Parity None
Stop bits 1
DTR Ignored
Duplex Full
Echo Off
Flow control X-on/X-off