3Com CoreBuilder 9000, User Manual

Page: 46 / 468

46 C
HAPTER
3: I
NTEGRATED
F
AST
S
ETUP
Setup Procedure
Sections
Table 6 lists the steps or sections of the Integrated Fast Setup.
Entering Data The Integrated Fast Setup procedure runs sequentially through the
relevant data for all of the sections, displaying a prompt for each data
item and a default value. If you want to change the default, enter a
different value in place of the default. If you want to accept the default,
press Enter.
Navigation Aids Table 7 lists the shortcut characters that you can use to move between
sections of the Integrated Fast Setup procedure:
Integrated Fast Setup
Operation
For step-by-step instructions, see the CoreBuilder 9000 ATM Switch
Fabric Module Getting Started Guide.
Table 6 Integrated Fast Setup Procedure Sections
Setup Section Description
1 Network Prefix Set Network Prefix for the CoreBuilder 9000 ATM
Enterprise Switch
2 LE Parameters Set LE parameters for the CoreBuilder 9000 ATM
Enterprise Switch
3 LECS Address Set active LECS address for the CoreBuilder 9000 ATM
Enterprise Switch
4 UNI/NNI parameters Set UNI/NNI port parameters for ports in the ATM
Interface Module
5 IP and Management
Configuration Set IP address of the switch, address of the NMS
application, default gateway address, and subnet mask
6 Confirmation Confirm setup operation
Table 7 Integrated Fast Setup Procedure Navigation Aids
Type To Go
< Back to previous section
> To next section
>S To section indicated by double underlined ID letter S in section title
\ Back to beginning of setup
$ To end of setup