38
ATM I
NTERFACE
M
ODULE
Q
UICK
S
TART
G
UIDE
Configuring the ATM Switch Fabric Module
After you have physically connected the ATM Interface Module to your
site network devices and power has been applied, you must define some
parameters that enable the ATM Switch Fabric Module to function within
the network.
The CoreBuilder 9000 Enterprise ATM Switch local management software
features an Integrated Fast Setup procedure that configures the
CoreBuilder 9000 Enterprise Switch and all ATM Interface Modules that
are installed in the CoreBuilder 9000 in one process.
Although there are other methods that can be used to define the
parameters (discussed in the
Switch Fabric Module User Guide
), the Fast
Setup is the fastest and easiest method of defined the essential
parameters needed to get your network running.
3Com recommends that you run the fast setup program after you have
installed the ATM Interface and Switch Fabric modules.
If you are installing the ATM Interface Module and the ATM Switch Fabric
Module at the same time, you only need to perform the Integrated Fast
Setup procedure once; both modules will be configured.
If you have already installed and configured the CoreBuilder 9000
Enterprise ATM Switch and you now wish to add a new ATM Interface
Module, perform the Integrated Fast Setup procedure again but now you
configure only the UNI/NNI parameters section for the ports of the new
ATM Interface Module.
Starting Up
In order to log in to the LMA, you need:
The desired access level
Your password
LMA Access Level
The LMA has three levels of access: read access,
write access, and administrate access. Each level grants different access
privileges and is suited to a different type of user. Table 6 lists the
privileges granted for each access level.
