3Com CoreBuilder 3500, Getting Started Manual

Page: 32 / 96

32 C
HAPTER
4: C
ABLING
Figure 11 Cabling the System Processor Serial Ports
You are now ready to configure your system for
management access through the serial ports. See
Chapter 6.
Cabling the Out-of-band Port
To connect the out-of-band Ethernet port:
1 Insert one end of the 10BASE-T cable into the RJ-45
jack that is labelled 10BT. See Figure 12.
2
Attach the other end of the 10BASE-T cable to your
PC, workstation, or other networking device.
Figure 12 Cabling the Out-of-band Port
You can also access the system processor through any
module’s Ethernet port using Telnet or rlogin.
You are now ready to configure your system for
management access through the out-of-band
Ethernet port. See Chapter 6.
VICE
INS
MODEM TERMINAL
ETHERNET
10BT
1X
L E T 2X
L E T 3X
L E T 4X
L E T 5X
L E T 6X
L E T
100 BASE - TX
3C35210
PWR
INS
ERR
DB-9 Connectors
Modem port Terminal port
VIC
INS
MODEM
TERMINAL
ETHERNET
10BT
1X
L E T 2X
L E T 3X
L E T 4X
L E T 5X
L E T 6X
L E T
100 BASE - TX
3C35210
PWR
INS
ERR
Out-of-band Ethernet port
Male RJ-45
connector