5-74
C
HAPTER
5: C
OMMAND
L
INE
I
NTERFACE
Example
802.1x-supplicant enable
This command enables the access point to operate as an 802.1X supplicant for
authentication. Use the
no
form to disable 802.1X authentication of the access
point.
Syntax
802.1x-supplicant enable
no 802.1x-supplicant
Default
Disabled
Command Mode
Global Configuration
Command Usage
A user name and password must be configured first before the 802.1X
supplicant feature can be enabled.
Example
802.1x-supplicant user
This command sets the user name and password used for authentication of the
access point when operating as a 802.1X supplicant. Use the
no
form to clear the
supplicant user name and password.
Syntax
802.1x-supplicant user
<
username> <password>
no 802.1x-supplicant user
•
username -
The access point name used for authentication to the network.
(Range: 1-32 alphanumeric characters)
•
password
- The MD5 password used for access point authentication.
(Range: 1-32 alphanumeric characters)
Enterprise AP(config)#802.1x session-timeout 300
Enterprise AP(config)#
Enterprise AP(config)#802.1x-supplicant enable
Enterprise AP(config)#
Summary of Contents for 3CRWE876075 / WL-546
