10/100BASE-TX F
AST
E
THERNET
M
ODULE
I
NSTALLATION
G
UIDE
3
Before You Install
Before you install your new module, follow the appropriate preinstallation
instructions in this section, depending on whether you are installing the
initial 10/100BASE-TX module or replacing one.
Read before
installing in an
empty slot
Your system is shipped with no modules installed and with protective
faceplates covering the installation slots. Before you install the module,
remove the protective faceplate that covers the selected installation slot.
To remove the faceplate:
1
Loosen the two captive screws that secure the faceplate to the chassis.
2
Move the injector/ejector handles to the outward position.
3
Pull the faceplate away from the system. See Figure 1. Save the faceplate
for future use.
Figure 1
Removing the Faceplate
RUN
SYS
INS
PS1
PS2
FAN
R
N
S
TEMP CONFIG
INS
PCMCIA
MODEM
TERMINAL
ETHERNET
10BT
PWR
ERROR
R
Captive screw
Faceplate
Injector/Ejector handle
