22
C
ONFIGURING
Y
OUR
O
FFICE
C
ONNECT
NETB
UILDER
10 B
RIDGE
/R
OUTER
c
Click Apply.
10
Add a default route to port 4 to tell the OfficeConnect
NETBuilder bridge/router which port to use to
communicate to the internet
a
In the Basic IP section of the navigation frame, click IP
Route.
b
In the ROUte field, enter the route:
0.0.0.0 !4 1
c
Click Apply.
11
In the Policy Management Network Address Translation
section on the navigation frame, click the NAT
IPCPAddressMap link.
a
In the start field, choose 4.
b
In the IPCPAddressMap field, enter Enable.
c
Click Apply.
12
In the Policy Management Network Address Translation
section on the navigation frame, click the NAT CONTrol
link.
a
In the start field, choose 4.
b
In the control field, choose Enable.
c
Click Apply.
13
In the Dial on Demand ISDN Setup section of the
navigation frame, click the PATH CONTrol link.
a
In the start field, choose 3.
b
In the CONTrol field, choose Enabled.
c
Click Apply.
14
Enable IP routing.
a
In the Basic IP section of the navigation frame, click the
IP CONTrol link.
b
In the CONTrol field, choose ROute.
c
Click Apply.
OC10.book Page 22 Thursday, May 13, 1999 2:33 PM
