3B RESmart CPAP, User Manual

Page: 25 / 40

3B
™
RESmart
®
CPAP and Auto-CPAP User Manual V3.0
29 | P a g e
Routine Maintenance
Replacing the Filter
1. Remove the filter cap by gently pressing on its bottom.
2. Change the filter.
a. Remove the foam filter by gently pulling around the edges of the
filter. Rinse the filter in a steady stream of running water. Squeeze out
the water and repeat. Air dries the filter on a rack for 8 to 12 hours or in
clothes dryer for 15 to 20 minutes.
b. Insert the filter (blue side out) into the filter area on the back of the
RESmart® CPAP and Auto-CPAP. Replace the filter cap.
CAUTION!
Operating the RESmart® CPAP and Auto-CPAP with a dirty filter may
keep the system from working properly and may cause damage to the
device.
Never install a wet filter into the device. We recommend that you
clean the filter in the morning and alternate using the filter provided
with the system to ensure enough drying time for the cleaned filter.
Cleaning the System
Clean the mask and tubing daily.
WARNING!
To avoid electrical shock, unplug the RESmart
®
CPAP and Auto-CPAP
before cleaning. Do not immerse the RESmart
®
CPAP and Auto-CPAP in
any fluids.
1. Disconnect the flexible tubing from the RESmart® CPAP and Auto-
CPAP. Gently wash the flexible tubing in a solution of warm water
and a mild detergent. Rinse the tubing thoroughly and air dry.
2. Wipe the outside of the RESmart® CPAP and Auto-CPAP with a
cloth slightly dampened with water and a mild detergent. Let the
RESmart® CPAP and Auto-CPAP dry before plugging in the power
cord.