24
Last revised 16.02.12
By pressing the “SET” key you can then have the current parameters (initial setting) of the unit shown as follows:
200mW
A
240.0J
CW
The display always shows the values for laser power level, point search program, therapy program, and energy dose
rate that were selected last (stored).
When the unit is operated for the first time, the maximum output of 200 mW, the operation mode CW, point search
mode OFF (0) and the maximum energy dose rate are always preset.
The parameters can be modified as explained in the chapter “Changing the Laser Parameters”.
The laser discharge is started as explained in the chapter “Using the Laser”.
Changing the Laser Parameters
When the SET key (3) is pressed, the output value flashes as in the illustration below and can be changed with the
“+” and “-” keys (2). The settings can be between 10 % and 100 % (related to the max. value) in 10 % increments.
100mW
M
120.0J
CW
By pressing the SET key (3) again, the selected value is confirmed and stored. The display changes to the following
screen. The point search mode can now be altered with the “+” and “-” keys (2).
100mW
M
120.0J
CW
The setting options for the point search mode are “0” (point search off), “M” (manual point search) and “A” (automatic
point search). (See the chapter “Point Search”. By pressing the SET key (3), the selected value is confirmed and stored.
The information on the screen changes into the following display.
100mW
M
120.0J
CW
The therapy program can be changed with the “+” and “-” (2) keys and saved with the SET key.
The setting options are:
CW – Multifrequency – Alpha frequency – Nogier frequencies A–G – Bahr frequencies 1–7 – Reininger frequencies
1–12 – Chakra frequencies 18 – Nogier frequencies pot. A’–G’ – freely programmable frequencies between 1 and
10,000 Hz
For therapy programs and frequencies, see Appendix 1.
Summary of Contents for Laser Pen 200 mW
Page 72: ...74 ...
