3
5. Current measurements
The Escola 30 is
not permitted
to be
used for measurements on low-volt-
age mains distribution equipment,
such as mains sockets, circuit breakers
and fuses etc.
The nominal voltage of the electricity
source must not exceed 30 V and its
nominal current must be no higher
than 3 A.
The multimeter is to be connected
in series with the load on the side
where the voltage with respect to
ground is lowest!
Turn off the circuit before the Es-
cola 30 meter is connected into it.
Connect the side with the lower potential to
the left-hand socket.
Connect the common/ground lead first and
only then the signal lead.
5.1 DC currents (mA=):
Set the rotary switch to the desired DC current
range. If measurements are made when the
magnitude of the variable is unknown, always
select a large measuring range before shifting
down to lower ones.
Set the three-way switch to
or, if the
zero point is to be set in the centre, to
.
5.2 AC currents (mA~):
Set the rotary switch to the desired AC current
range. If measurements are made when the
magnitude of the variable is unknown, always
select a large measuring range before shifting
down to lower ones.
Set the three-way switch to
.
6. Voltage measurements
The Escola 30 is
not permitted
to be
used for measurements on low-volt-
age mains distribution equipment,
such as mains sockets, circuit breakers
and fuses etc.
The nominal voltage of the voltage
source must not exceed 30 V.
Connect the side with the lower potential to
the left-hand socket.
Connect the common/ground lead first and
only then the signal lead.
6.1 DC voltages (V=):
Set the rotary switch to the desired DC voltage
range.If measurements are made when the
magnitude of the variable is unknown, always
select a large measuring range before shifting
down to lower ones.
Set the three-way switch to
or, if the
zero point is to be set in the centre, to
.
6.2 AC voltages (V~):
Set the rotary switch to the desired AC voltage
range.If measurements are made when the
magnitude of the variable is unknown, always
select a large measuring range before shifting
down to lower ones.
Set the three-way switch to
.
Symbols for measuring ranges
mA= DC (unit mA)
mA~ AC (unit mA)
V=
DC voltage (unit V)
V~
DC voltage (unit V)
~
~
~
~
~
~
~
~
Summary of Contents for Escola 30
Page 6: ......
