，
Note:
A small patch of electronic components for special
purposes is marked with "X" in the table (such as high
voltage resistors, ceramic resistors, diodes), in which
the lead content may exceed 0.1 % . As the screws and
the core in the data cables using alloy with better
performance, the lead content may also be exceed
0.1 %. These components are in accordance with the
requirements of the exemption clause of the EU RoHs
directive. Limited by the current global technology
development, there are no other alternative technolo
gies and components. The external lead contents of
these components are in accordance with enviornmen
tal protection requirements.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2)
this device must accept any interference received,
including interference that may cause undesired
operation.
Note:
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
Any Changes or modifications not expressly approved
by the party responsible for compliance could void the
user's authority to operate the equipment.
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment. This
equipment should be installed and operated
withminimum distance 20cm between the「adiator &
your body.
009
010
